Kayak Boat Plans
Knocked off a few niggling little jobs today. Its been hard to work around uni and last night was my first good sleep all week (3am - 11am). will be no such luxury tonight, this counts as procrastinating and i have a meeting at 1pm tomorrow (sunday!) and about form now till then worth of exploded axonometric diagram to do...
Anyway i got the bell cranks designed and cut out. All the linkage bits i pretty much thought up as i went along, though i had a vague idea of what i wanted; they definitely had to be bigger than before, and i wanted to minimise friction and slack as much as possible. The little carbon forks on the fibreglass rods I think were a good idea, easy to make, we will see whether they hold together or not. they look pretty tough anyway. My little stainlless threaded fork is an M5 turnbuckle body that i cut up, and took about 5 minutes to make with the grinder. The thread is done for you its great.
I also took the opportunity to finish off the cams and do the wand as well. The centreboard system is pretty done save a bit of bog and the ball joint on the flap. Im waiting until Ive done the gantry before i cut the rudder to length and put its linkages together.
I checked the centreboad foil angle of attack today too (first time in the boat) and its what i wanted (good management more than anything i think!) between +1.5 and +1.8 degrees on roungh calculations. Much more than that and you start paying drag penalties, but form memory up to about that range you only gain 1% or 2% Cd but significant Cl.
Do you find information about Kayak Boat Plans are you looking for? If not, below may help you find more information about the Kayak Boat Plans. Thank you for visiting, have a great day.
